[elrepo] ENA version not printing correctly

[Phil Perry]

On 31/07/2020 08:38, Danie de Jager via elrepo wrote:
> Hi,
> 
> I noticed that the version for ENA is the same as the kernel version 
> rather than a known version like version: 2.0.3K. Is this done by design?
> 
> # ethtool -i eth0
> driver: ena
> version: *5.7.11-1.el7.elrepo.x86_64*
> firmware-version:
> expansion-rom-version:
> bus-info: 0000:00:05.0
> supports-statistics: yes
> supports-test: no
> supports-eeprom-access: no
> supports-register-dump: no
> supports-priv-flags: no
> 
> vs another system not using Elrepo
> 
> # ethtool -i ens5
> driver: ena
> *version: 2.0.3K*
> firmware-version:
> expansion-rom-version:
> bus-info: 0000:00:05.0
> supports-statistics: yes
> supports-test: no
> supports-eeprom-access: no
> supports-register-dump: no
> supports-priv-flags: no
> *Danie de Jager* * • * *Security Analyst* * • * *Striata*
> *T.* *+27 011 5309600* * | * *www.striata.com 
> <https://www.striata.com/?utm_source=email&utm_medium=striataEmailFooter&utm_campaign=daniede+jager>* 
> 
> 

Hi,

No it's not done by design, and am not sure why ethtool is picking up 
the kernel version instead of the module version.

What version information does 'modinfo ena' show?

Phil